Publicité
OPERATION IN CASE OF EMERGENCY
In the event of any fault:
•
Turn off the appliance,
•
Disconnect the power supply
•
By following the instructions given in the table below, the user can correct some minor
issues. Please check the consecutive points in the table before you refer the repair to
customer service.
Problem
1. The appliance does not
work
2. Oven lighting does not
work
3. Display shows blinking
time "0.00"
4. Fan does not work
5. E1 Error on the display
6. E0 Error on the display
If the problem is not solved, disconnect the power supply and report the fault to the nearest
service centre. Note! All repairs must be performed by qualified service technicians.
Reason
no power
loose or damaged bulb
The appliance was un-
plugged or there was a
power outage.
Risk of overheating! Immediately unplug the appliance or
switch off the main circuit breaker. Refer the repair to the
nearest service centre.
Meat probe failure
oven chamber sensor error
109
Remedy
check the fuse, replace if
blown
Replace the blown bulb
(see Cleaning and main-
tenance)
Set the current time (see
section "Programmer
operation")
you can use the oven
without the meat probe
disconnect the appliance
from wall socket (fuse)
and contact the nearest
service centre
Publicité
