Bitzer CM-RC-01 Instructions De Montage page 26

Configuration via BEST SOFTWARE (see figure 4,
page 26)
At least the following parameters need to be set / selec-
ted in the C menu:
ONFIGURATION
• Compressor type.
• Refrigerants.
• Motor starter function.
• Serial number of the compressor.
Depending on the equipment installed, the following
parameters may have to be enabled:
• Type of start unloading.
• Additional fan.
• CRII capacity control and the number of capacity
regulators installed.
• Monitoring of application limits.
• Low pressure and high pressure switches.
Once you have set all parameters, transfer the settings
to the device.
Fig. 4: Transferring user settings to the compressor module
26 KW-233-2