Bitzer CM-RC-01 Instructions De Montage page 24

▶ Connect the cable of the low pressure transmitter to
terminal strip CN12, terminals 4, 5, 6 (designation
"psuc") on the compressor module.
▶ Pay attention to the correct cable connections!
If no additional extension kits are mounted:
• Proceed with the other electrical connections on the
CM-RC-01 (see chapter Further electrical connec-
tions on the CM-RC-01, page 21).
• Mount the cable holders, lay the cables and close
the cable ties (see chapter Mounting the cable hold-
ers and laying the cables, page 21).
• Screw the protective earth conductor onto the ter-
minal box cover and attach the cover to the module
housing (see chapter Closing the module housing,
page 21).
4.3 Mounting the "Additional fan" extension kit
Information
For details, see Technical Information KT-140.
▶ Loosen the relevant screws on the cylinder head, fit
the fixing plates and screw tight (tightening torque
80 Nm).
24
▶ Use the enclosed screws and nuts (see small figure)
to fasten the fan feet.
▶ Pass the cables through the cable glands on the
compressor module into the module housing and
connect them to the CN5 terminal strip.
If no additional extension kits are mounted:
KW-233-2