Bitzer CM-RC-01 Instructions De Montage page 18

3.3 Unscrewing the terminal box from the
compressor
▶ Loosen the 5 marked fixing screws in the com-
pressor terminal box and remove the terminal box
from the compressor.
3.4 Mounting the fixture of the compressor
module
▶ Position the seal (left figure), then put the fixture on
top (right figure).
18
▶ Then put the compressor terminal box onto the fix-
ture and fasten everything to the compressor using
the 5 screws in the terminal box.
3.5 Fastening the cable conduit to the terminal
box
▶ Fasten the cable conduit pre-mounted to the com-
pressor module to the open (M16) cable bushing of
the compressor terminal box and guide the two
cables of the motor temperature monitoring (orange
colour on the photo) and the protective earth con-
ductor into the terminal box.
▶ Connect the two cables of the motor temperature
monitoring (orange colour on the photo) of the com-
pressor module to the terminal plate of the com-
pressor.
▶ Screw the protective earth conductor of the com-
pressor module onto the earth bolts in the terminal
box.
KW-233-2