Bitzer CM-RC-01 Instructions De Montage page 19

▶ Close the terminal box and screw down the cover.
3.6 Screwing the compressor module onto the
fixture
▶ Position the compressor module on the fixture in
such a way that the cable bushings point towards
the motor cover (see figure).
▶ Screw the compressor module to the fixture using
the 4 enclosed screws. To this end, put the screws
into the guide rails from below.
KW-233-2
3.7 Connecting the oil heater
▶ Put the oil heater cable through a screwed cable
gland on the compressor module and connect it to
the CN4 terminal strip.
Information
For oil heater mounting, see Technical Informa-
tion KT-150.
▶ Guide the oil heater cable to the compressor mod-
ule as shown in the figure.
19