Doro congress 100 Manuel D'utilisation page 6

English
Technical information
Some selector switches are located in a compartment on the underside of the
telephone.
These switches control technical parameters for connection to PBX equipment.
You remove the lid by pressing a small screwdriver (max. Ø 2,5mm) or similar in the
hole to the right of the lid.
IMPORTANT NOTE: These switches should only be adjusted by qualified personnel.
Recall time
Selection of 100/300/600ms timed loop break for recall functionality.
The standard setting is 100 ms for UK/Australia and 600 ms for New Zealand.
Tone/Pulse (♫/...)
Selection of either dialling method depending on PBX.
Message Waiting Indicator
Some PBX systems have a function called Message Waiting.
On the under side of the telephone is a switch marked (MW), this is used to select one
of the following options: LED+, LED-, Visual Ring Indicator ( ) and high voltage
(HV).
By selecting the appropriate option for your system the telephone will indicate if there
are any voice mail messages available.
This function operates differently depending on the PBX system in question therefore
please contact your system administrator for more information.
If the unit is not connected through a PBX please select ring indication ( ).
Declaration of conformity
Doro declares that the apparatus Doro Congress 100 complies with the essential
requirements and other relevant positions of Directive 1999/5/EC, 2002/95/EC. A
copy of the Declaration of Conformity can be found at www.doro.com/dofc
Troubleshooting
Check that the telephone cord is undamaged and properly plugged in.
Disconnect any additional equipment that may be connected.
If the problem is resolved the fault is with the other equipment.
Test the equipment on a known working line, if the product works then the fault is
with the line.
If you are still experiencing difficulties, contact the Technical helpline.