Publicité
All manuals and user guides at all-guides.com
Activating cleaning mode
• In cleaning mode, the flush actuation is
suppressed for 10 minutes. During this
time, you can clean the urinal or replace
the urinal trap.
• You can only activate cleaning mode
30 minutes after activating the power
supply or setting the flush time.
• You can also activate cleaning mode with
Geberit Clean Handy.
Prerequisite
–
Refer to illustration sequence
page 38 while carrying out the
instructions.
1
Hold a white sheet of paper in front
of the IR sensor on the bottom edge
of the urinal ceramic appliance for at
least 2 seconds.
2
Remove the white sheet of paper
after 2 short signal tones.
✓ The flush actuation is
deactivated and suppressed for
10 minutes. During this time,
you will hear a signal tone every
4 seconds.
3
Clean the urinal ceramic appliance
and replace the urinal trap.
Result
✓ Once 10 minutes have elapsed, a flush
is actuated.
7021420811-1 © 01-2020
969.653.00.0(00)
Cleaning or replacing the
spray head
• Clean the cover for the spray head and
the nozzle with a mild, liquid cleaning
agent at least once a year.
• Descale the nozzle with a commercially
available descaling agent if necessary.
• Replace the nozzle if it can no longer be
completely cleaned and descaled.
Prerequisite
–
Refer to illustration sequence
1
,
page 41 while carrying out the
instructions.
1
2
3
4
5
6
7
Result
✓ The urinal is ready for operation.
Demount the urinal flush control to
disconnect the water supply. → See
illustration sequence
2
Demount the cover for the spray
head.
Demount the nozzle.
Clean the nozzle and rinse with
water, or replace the nozzle (art. no.
243.333.00.1).
Mount the nozzle.
Mount the cover for the spray head.
Mount the urinal flush control. →
See illustration sequence
page 40.
EN
4
,
, page 39.
3
,
9
Publicité
