Publicité
All manuals and user guides at all-guides.com
10
Plug in the cable for the battery or
rechargeable battery compartment.
→ See illustration sequence
page 46.
11
Mount the urinal flush control. →
See illustration sequence
page 40.
Result
✓ The urinal is ready for operation.
7021420811-1 © 01-2020
969.653.00.0(00)
Setting the flush time
You must set the flush time within the first
10
,
30 minutes after activating the power
supply.
Prerequisite
3
,
–
Refer to illustration sequence
page 44 while carrying out the
instructions.
1
2
3
4
5
Result
✓ The flush time is set. The urinal is ready
for operation.
Restart the urinal flush control. →
See Restarting the urinal flush
control.
✓ The urinal flush control restarts.
Hold a white sheet of paper in front
of the IR sensor on the bottom edge
of the urinal ceramic appliance for at
least 2 seconds.
✓ 2 short signal tones will sound
after 2 seconds.
Remove the white sheet of paper.
Hold your hand in front of the IR
sensor within 10 s econds.
Remove your hand after the
required number of signal tones.
✓ As soon as you place your hand
in front of the sensor, the flush is
actuated. 1 signal tone
corresponds to a flush volume of
approx. 0.2 l. Example: 12 signal
tones = approx. 2.4 l.
✓ 2 short signal tones confirming
the setting will sound 2 seconds
after you have taken your hand
away.
EN
7
,
11
Publicité
