Publicité
ZEPHYRONLINE.COM
Enabling ACT™
To enable ACT™:
1. Press the Up/Down button to fully raise the chimney. After it has risen, turn off the downdraft.
2. Remove the front panel by lifting it directly up (FIG. O1) and pulling it away (FIG. O2).
3. Locate the ACT™ screw hole at the right side panel on the bottom (FIG. P).
4. Insert the ACT™ screw (FIG. Q).
5. Fully tighten screw to enable ACT™.
6. Remove the appropriate foil CFM sticker included with the hood literature and place inside the
hood body below the wiring diagram or in another clearly visible location (FIG. R).
1
FIG. O
ACT™ screw
3/16 x 1"
FIG. Q
Treviso Use, Care, and Installation Guide
2
ACT™ screw hole
ACT™ Conversion
ACT™ screw hole
FIG. P
CFM sticker placement
FIG. R
25
Publicité
