Publicité
Installation Instructions
Planning
This downdraft blower system is designed to
be used to exhaust airborne contaminants
when cooking with a variety of gas or electric
cooktops. It can be mounted in island, peninsula,
or convential wall locations. This unit can be
easily installed following these basic steps:
►
Cut out the countertop opening.
►
Mount the unit in the cabinet.
►
Connect the ductwork and electrical.
►
Install the cooktop.
NOTE: The high level of air flow of this appliance
may affect the gas flame on some types
of gas cooktops. This is NORMAL and will
cause no harm, but can be corrected by
lowering the speed of the blower.
Countertop
Electronics Box
Blower Housing
Blower
NOTE: The electronics box can be relocated to
the left or right side of the blower housing.
10
Cooktop
Chimney Top
Taking Measurements
Cooktop
Countertop
Front to Back Inside Cabinet Depth
Downdraft
Refer to the cooktop installation instructions for
dimensions of cooktops, countertop cut-out, and
cabinet requirements. The ZTV-E30AS model will
fit in most 30" wide cabinets, and the ZTV-E36AS
model will fit in most 36" wide cabinets. However,
it is recommended that oversized cabinets
be used for easier installation. Custom island
designs need to account for deeper cabinets,
especially when installed with a range in front
of the downdraft or when mounting the blower
behind the downdraft. You must also plan for an
access door.
Cooktop depth can vary greatly from one to
another. This may cause the fit of these two
appliances to be rather tight. Pay special
attention to the areas of potential interference
highlighted above. A countertop with a raised
lip (A) and/or a backsplash (B) may not allow
enough flat countertop for a proper installation.
Note that 2-7/8" of flat countertop is required
behind the cooktop and that 2-3/4 is necessary
between the back edge of the cooktop and
inside of the cabinet back.
Treviso Use, Care, and Installation Guide
C O R E
T R E V I S O
D O W N D R A F T
2-
"
3/4
2-
"
7/8
Publicité
