Publicité
ZEPHYRONLINE.COM
Hood & Filter Cleaning
Surface Maintenance
►
Do not use corrosive detergents, abrasive detergents or oven cleaners.
►
Do not use any product containing chlorine bleach or any product containing chloride.
►
Do not use steel wool or abrasive scrubbing pads which will scratch and damage surface.
Cleaning Stainless Steel
Clean periodically with warm soapy water and clean cotton cloth or micro fiber cloth. Always rub
in the direction of the stainless steel grain. To remove heavier grease build up use a liquid degreaser
detergent.
After cleaning use a non-abrasive stainless steel polish/cleaners, to polish and buff out the stainless
luster and grain. Always scrub lightly, with clean cotton cloth or micro fiber cloth and buff in the
direction of the stainless steel grain.
Cleaning the Grease Filters
The grease filters are intended to trap residue and grease from cooking. Although the filters should
never need replacing, they are required to be cleaned every 30 days or more often depending on
cooking habits.
Grease filters may be placed in dishwasher at low heat or soaked in hot soapy water. Dry filters and
reinstall before using hood.
To remove the grease filters, please follow the
instructions below:
1. Fully raise the downdraft chimney by pressing
the Up/Down button. Make sure the downdraft is
off afterward by sliding the switch to 0 from the
mechanical switch controls.
2. The front panel is secured by hanging off of four
latches. Remove the front panel by grabbing the
top, lifting it directly up, and pulling it away (FIG. N).
From there, the grease filters should be visible.
3. Remove the grease filters by lifting them out.
Treviso Use, Care, and Installation Guide
Maintenance
FIG. N
23
Publicité
