Publicité
NOTE: If the cabinet depth including the cabinet doors is
more than 13" then the unit must be spaced out from wall using
adequate materials supporting 150Ibs to allow proper top vent
air exhaust/intake.
Cabinet
Cabinet
1.
Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the holes
designated to go into drywall and reattach the toggle
wings to 3/4" (19mm) onto each bolt.
Cabinet
3. Place the mounting plate against the wall and insert the
Spacing for Toggles
toggle wings into the holes in the wall to mount the plate.
Spacing for Toggles
More Than Wall
NOTE: Before tightening toggle bolts and wood screw, make
More Than Wall
Thickness
Thickness
sure the bottom of the mounting plate touch the bottom of the
Toggle Wings
Toggle Wings
cabinet when pushed flush against the wall and that the plate is
Mounting
Mounting
Plate
properly centered under the cabinet.
Plate
Be careful to avoid pinching fingers between the back of the
mounting plate and the wall.
Wall
Wall
4. Tighten all bolts. Pull the plate away from the wall to help
tighten the bolts.
Spacing for Toggles
More Than Wall
Thickness
Toggle Wings
Mounting
Plate
Wall
Cabinet
Cabinet
Cabinet
Cabinet
Toggle
Toggle
Bolt
Bolt
CAUTION
Bolt End
Bolt End
Toggle
Bolt
Bolt End
Cabinet
A2: Use Top Cabinet Template for
Preparation of Top Cabinet
NOTE: Cabinet depth maximum in exhaust mode is 141/2"
(37cm).
You need to drill holes for the top support screws and a hole
large enough for the power cord to fit through.
Toggle Wings
Mounting
1.
Read the instructions on the TOP CABINET TEMPLATE.
Plate
2. Tape the TOP CABINET TEMPLATE underneath the top
cabinet.
NOTE: Adjust top template accordingly if the microwave
is being spaced out from the wall due to cabinet depth
(including cabinet doors) of more than 13".
Wall
3. Drill the holes, following the instructions on the TOP
CABINET TEMPLATE..
Wear safety goggles when drilling holes in the cabinet
bottom.
Cabinet Front
Cabinet Front
A3: Check Blower Plate
Cabinet Front
●
Place the microwave in its upright position, with the top of
the unit facing up.
●
Check to see that the blower plate is correctly installed on
the unit.
A4: Mount the Microwave Oven
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle or heat shield
during installation. Do not remove the cardboard spacers
between the heat shield and door.
- 8 -
Spacing for Toggles
More Than Wall
Thickness
Toggle
Bolt
Bolt End
CAUTION
Cabinet Bottom Shelf
Cabinet Bottom Shelf
Filler Block
Filler Block
Blower Plate
Self-Aligning Screw
Self-Aligning Screw
Microwave Oven Top
Microwave Oven Top
Cabinet Bottom Shelf
Filler Block
Self-Aligning Screw
Microwave Oven Top
`CCD-0006072 Rev: 11-15-23
Blower Plate
Equivalent to Dep
Equivalent to Dep
of Cabinet Recess
of Cabinet Recess
Equivalent to Dep
of Cabinet Recess
Publicité
