Télécharger Imprimer la page

Furrion FMCM15A-BL Manuel D'installation page 10

Masquer les pouces Voir aussi pour FMCM15A-BL:

Publicité

NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord. We
recommend using filler blocks if the cabinet front hangs below
the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case damage may
occur from over tightening screws.
NOTE: When mounting the microwave oven, thread the power
cord through the hole in bottom of top cabinet. Keep it tight
throughout steps 1–3. Do not pinch cord or lift oven by pulling
cord.
Blower Plate
1.
Lift microwave, tilt it forward, and hook slots at back
bottom edge onto four lower tabs of mounting plate.
2. Rotate front of oven up against cabinet bottom.
Blower Plate
Cabinet Front
Cabinet Bottom Shelf
3. Insert a self-aligning screw through top center cabinet hole.
Temporarily secure the oven by turning the screw at least
Cabinet Front
two full turns after the threads have engaged. (It will be
completely tightened later.) Be sure to keep power cord
Cabinet Bottom Shelf
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
Self-Aligning Screw
Cabinet Front
Microwave Oven Top
Cabinet Bottom Shelf
Microwave Oven Top
Microwave Oven Top
4. Attach the microwave oven to the top cabinet.
5. Insert 2 self-aligning screws through outer top cabinet
holes. Turn two full turns on each screw.
CCD-0006072 Rev: 11-15-2023
Blower Plate
Filler Block
Equivalent to Depth
of Cabinet Recess
Filler Block
Equivalent to Depth
of Cabinet Recess
Filler Block
Self-Aligning Screw
Equivalent to Depth
of Cabinet Recess
Self-Aligning Screw
6. Tighten the outer two screws to the top of the microwave
oven. (While tightening screws, hold the microwave oven in
place against the wall and the top cabinet.)
7.
Install grease filters. See the User Manual packed with the
microwave.
A5: Installing or Change the Charcoal
Filter (Some Models)
NOTE: The charcoal filter is factory installed in some models.
Refer to the User Manual to see if yours is factory installed and
for replacement information.
For models without the recirculation filter access door, follow
these steps to replace or install a charcoal filter.
1.
Unplug microwave oven or disconnect power.
2. Open the microwave door and remove the two vent
mounting screws located on top of the microwave using a
#1 Phillips screwdriver.
3. Remove the charcoal filter by pushing the top of the filter
inwards, then pull it forward out from the unit.
- 9 -
Charcoal
Filter
Charcoal
Filter

Publicité

loading