Publicité
Shipment/Installation
DANGER
●
If the unit is damaged in shipment, return the
unit to the store in which it was bought for repair or
replacement.
●
If the unit is damaged by the customer, repair or
replacement is the responsibility of the customer.
●
If the unit is damaged by the installer (if other than
the customer), repair or replacement must be made by
arrangement between customer and installer.
BEFORE USING
1.
Make sure the microwave oven has been installed
according to instructions.
2. Remove all packing material from the microwave oven.
3. Install turntable and ring in cavity.
4. Replace house fuse or turn breaker back on.
5. Plug power cord into a dedicated 15amp to 20amp
electrical outlet.
6. Read the User Manual.
7.
Keep installation manual for the local inspector's use.
Parts Included
Part
Description
Wood Screws (1/4" x 2")
Toggle Bolts (and wing nuts) (3/16" X 3")
Self-Aligning Machine Screws
(1/4"-28 x 31/4")
Nylon Grommet (for metal cabinets)
Top Cabinet Template
Rear Wall Template
INSTALLATION
MANUAL
Installation Manual
Separately Packed Grease Filters
Exhaust adapter
Mounting Plate
Sheet Metal Screw (3/16" x 5/16")
Washer (match with 1/4" self-aligning
machine screws)
You will find the installation accessories contained in a packet
with the unit. Check to make sure you have all these parts.
NOTE: Some extra parts are included.
CCD-0006072 Rev: 11-15-23
Save these instructions for
future reference!
Tools You Will Need
Part
Quantity
2
2
3
1
1
1
1
2
1
1
2
2
- 3 -
Description
Level
Duct and masking tape
#1 Phillips screwdriver
Pencil
Tin snips (for cutting damper, if required)
Scissors (to cut template, if necessary)
Filler blocks or scrap wood pieces, if needed for
top cabinet spacing (used on recessed bottom
cabinet installations only
Gloves
Safety goggles
Stud finder or Hammer (optional)
Carpenter square (optional)
Ruler or tape measure and straight edge
Electric drill with 3/16", 1/2" and 5/8" drill bits
Saw (saber, hole or keyhole)
Publicité
