Publicité
INSTALLATION
Mounting Space
In Exhaust Mode
Bottom edge of cabinet needs to
(See Installation Types B & C on page 7):
be
Cabinet depth 14" Maximum (35.6 cm)
cooking surface
In Recirculating Mode
(See Installation Types A on page 7):
Cabinet depth
13" Maximum (33 cm)
16 ½" (41.9 cm)
66
(167.6 cm)
"
or more from
the floor to the
top of the
microwave
NOTE:
●
The space between the cabinets must be 30" (76.2cm)
wide and free of obstructions.
●
If the space between the cabinets is greater than 30"
(76.2cm), you'll need filler material to fill the gap between
the microwave oven and the cabinets.
●
If you are going to vent your microwave oven to the
outside, see Hood Exhaust section for exhaust duct
preparation.
●
When installing the microwave oven beneath smooth, flat
cabinets, be careful to follow the instructions on the top
cabinet template for power cord clearance.
Placement of the Mounting Plate
Removing the Microwave Oven From the
Carton / Removing the Mounting Plate
1.
Remove the installation manual, user manual, exhaust
adapter, turntable ring, shelf, filters, glass tray and the small
hardware bag. Do not remove the Styrofoam protecting the
front of the oven.
Small Hardware Bag
Filters and Turntable
Ring below glass tray
30"
(76.2 cm) or more from the
¼"
min.
(Clearance to bottom of the door)
Max. depth of
cabinet and door
30"
Cabinet
(76.2 cm)
min.
Backsplash
Side View
Cabinet
Side View
Exhaust Adapter
Glass Tray
Carton
2. Fold back all 4 carton flaps fully against carton sides. Then
carefully roll the oven and carton over onto the top side.
The oven should be resting in the Styrofoam.
Door
Styrofoam
Styrofoam
3. Pull the carton up and off the oven.
Door
4. Cut the middle of the outer protective plastic bag to
remove the mounting plate.
Screws
Screws
5. Remove the screw from each end of the mounting plate.
This plate will be used as the rear wall template and for
mounting. Reinstall the screws into the holes where they
were removed.
Finding the Wall Studs
1.
Find the studs, using one of the following methods:
A. Stud finder – a magnetic device which locates nails.
B. Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate a wall stud
location.
2. After locating the stud(s), find the center by probing the
wall with a small nail to find the edges of the stud. Then
place a mark halfway between the edges. The center of
any adjacent studs should be 16" (40.6 cm) or 24" (61 cm)
from this mark.
3. Draw a line down the center of the studs.
NOTE: THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
Center
- 4 -
Glass Tray
Glass Tray
Screws
Screws
Mounting Plate
Mounting Plate
Wall
Studs
CCD-0006072 Rev: 11-15-23
Carton
Carton
Publicité
