Publicité
7.
Attach the exhaust adaptor to the top of the blower plate
by sliding it into the guides of the blower plate. Push in
securely until it is in the locking tabs. Take care to assure
that the damper hinge is installed so that the damper
swings freely.
Adaptor
Guide
B4: Check for Proper Damper Operation
Blower Plate
Exhaust Adaptor
●
Make sure tape securing damper is removed and damper
pivots easily before mounting microwave.
●
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave is installed.
B5: Mount the Microwave Oven
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle or heat shield
during installation. Do not remove the cardboard spacers
between the heat shield and door.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord. We
recommend using filler blocks if the cabinet front hangs below
the cabinet bottom shelf.
Back of
Microwave
Back of
Microwave
Locking Tab
Damper
Back of
Microwave
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screw
Microwave Oven Top
IMPORTANT: If filler blocks are not used, case damage may
occur from over tightening screws.
NOTE: When mounting the microwave oven, thread the power
cord through the hole in bottom of top cabinet. Keep it tight
throughout steps 1–3. Do not pinch cord or lift oven by pulling
cord.
1.
Lift microwave, tilt it forward, and hook slots at back
bottom edge onto four lower tabs of mounting plate.
2. Rotate front of oven up against cabinet bottom.
2
3. Insert a self-aligning screw through top center cabinet hole.
Temporarily secure the oven by turning the screw at least
two full turns after the threads have engaged. (It will be
completely tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
Cabinet Front
4. Attach the microwave oven to the top cabinet.
5. Insert 2 self-aligning screws through outer top cabinet
holes. Turn two full turns on each screw.
6. Tighten the outer two screws to the top of the microwave
oven. (While tightening screws, hold the microwave oven in
place against the wall and the top cabinet.)
7.
Install grease filters. See the User Manual packed with the
microwave.
- 12 -
Adaptor
Guide
Locking Tab
1
Cabinet Bottom Shelf
Filler Block
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screw
Microwave Oven Top
CCD-0006072 Rev: 11-15-23
Back of
Microwave
Publicité
