Publicité
and fire hazards.In the event of incompatibility between the power socket and the appliance's
plug, have the plug replaced with a suitable model by a qualified professional, who should
ensure that the cable is appropriate for the power rating of the device.The use of adaptors or
extensions is generally not advisable; if it is necessary to use them, they must comply with
safety regulations and the total current (amperes) must not be rated lower than the maximum
current of the appliance.
- There are no water, gas or power lines inside the wall
- The wall to which the appliance is to be fixed must be made of masonry and/or heat-resistant,
fire-retardant and solid material (not wood or synthetic material), flat and free of irregularities;
the ceiling must also be made of fire-retardant and heat-resistant material.
- the appliance can be installed at least 2.0m from the ground (height referred to the lower
edge of the appliance), is positioned so that it cannot suffer impacts and that the air outlet grid
has a free space of at least 100cm, and at least 40cm at the sides.If installed in a bathroom, in
addition to the height from the ground, it must be ensured that the switches and control
devices cannot be touched or reached by a person in the bathtub or shower.
- the appliance is away from other sources of heat, flammable materials (curtains, upholstery,
etc.), flammable gases or explosive materials (spray cans) and materials that can be deformed
by heat.
•
This appliance must not be used in any type of vehicle or restricted space (lifts, camper vans,
cars, cabins etc.).
• To install the appliance, proceed as follows and refer to the figures:
- The appliance must be fixed in such a way that it is horizontal and the air outlet grid is on the
underside.
- the fixing is provided by means of 2 screws that engage in the 2 "lock hole" slots made on the
rear panel.
Drill 2 perfectly horizontal
holes, with a distance of 39.5
cm and at least 215 cm from
the floor (to draw the holes
use the template obtained in
the
lower
package).Insert
expansion dowel and drive in
screws with head havinga
8mm diameter, suitable to fit
in the slots (see figure on the
side)
•
Ensure that the power cord is correctly positioned and does not come into contact with hot
parts or sharp edges, or become wound around the appliance itself and is not twisted.
•
In the event of a fault or malfunction, switch off the appliance and have it checked by a
qualified technician.
USO
The functions of this appliance can be started using they keyboard of the control panel or the
remote control which has to be pointed in the correct direction (at a max distance of 4m); for
the first use remove the plastic tab from the battery (N.1 battery type: CR2025)
flap
of
the
the
16
Publicité
