Publicité
EN
10) Reinsert the return hose into
the container. The sealing
grommet must be seated
correctly in the slot.
11) Hook in the two latches and
replace the lid on the container.
The
cover
i
not
close
Therefore, do not tilt
the device when filled.
Suck in material
Perform the following steps, without the spray tip
mounted to the gun.
1) Unlock the spray gun and
turn the PRIME/SPRAY knob
to PRIME.
2) Using the metal thread on
the gun, touch the edge of
a metal container to earth
the gun.
3) Actuate the trigger and
KEEP IT PRESSED.
4) Switch the pump on. Slowly
turn the speed control
clockwise to 2.
WARNING
Keep hands clear from fluid
stream.
5) While holding the trigger,
turn the PRIME/SPRAY knob
to SPRAY. Hold the trigger
until all air, water, or solvent
is purged from the spray hose
and paint is flowing freely.
6) Release trigger, turn the
PRIME/SPRAY knob to
PRIME and turn pump OFF .
32
PREPARATION
does
airtight.
Control Pro 300 Move 18V
7) Trigger the gun into the waste container once more to
be sure that no pressure is left in the hose.
8) Lock the spray gun off.
9) Thread the spray tip assembly onto the gun. Tighten by
hand.
10) Insert spray tip (tip pointing in the spray direction).
Your device is now ready for operation.
Publicité
