Publicité
IMPORTANT INFORMATION
EN
Preparing the paint
To avoid rapid blockage of the nozzle and filter, we
recommend stirring and sieving the paint well before
spraying. Follow the material manufacturer's instructions.
Select tip and gun filter
Use the proper gun filter based on the tip size being used.
Tip Size
Paint
311
For thin materials like acrylic
paints, primers, stains...
515
For thick materials like
internal emulsions, latex
paints, hollow-space
sealants..., ...
Locking and unlocking the gun
WARNING
Always lock the trigger off when attaching the spray tip
or when the spray gun is not in use.
Locking the gun
Fold the trigger lock down to
block the trigger.
Unlocking the gun
Fold the trigger lock up until
it engages to unlock the
trigger.
Earthing
WARNING
When processing materials containing solvents, the
appliance must be earthed.
1) Remove the earth screw and screw the enclosed earth
cable to the side of the appliance.
2) Attach the earth clamp to a suitable metal installation
(e.g. water pipe, radiator, garden fence).
30
Pressure relief procedure
Be sure to follow the pressure relief procedure when
shutting the unit off FOR ANY PURPOSE. This procedure
is used to relieve pressure from the spray hose.
1) Lock the spray gun off and
flip the ON/OFF switch to the
Filter
OFF position.
Red
2) Turn the PRIME/SPRAY knob
to PRIME.
white
3) Unlock the spray gun and
then trigger it onto a scrap
piece of wood or cardboard.
4) Lock the spray gun.
Dry running
Operation without liquid leads to increased wear and
damages the pump.
Never allow the device to run dry for more than 30
seconds.
One cause of blockages can be a clogged gun or inlet
filter/suction filter. Therefore, check and clean the filters
regularly.
Refilling the container / bleeding the pump
If the paint in the container runs out, it may be that air
is being aspirated into the system. When refilling, the
pump must be bled as described below in order to avoid
dry running.
1) Switch the pump off
immediately.
2) Refill the container.
3) Turn the PRIME/SPRAY knob
to PRIME.
4) Switch the pump back on
and wait until the paint is
flowing out of the return
hose.
5) Turn the PRIME/SPRAY
switch to the SPRAY
position and carry on
working.
Control Pro 300 Move 18V
WARNING
CAUTION
CAUTION
Publicité
