Publicité
Using the bit holder
After removing the chuck
holder
.
♦
Insert a suitable bit into the bit holder
♦
Push the bit into the bit holder
stop.
The guidance and the magnetic holder keep the
bit firmly in place.
♦
To remove the bit, pull it out of the bit holder
Use
Switching on and off
Switching the appliance on:
♦
Press the ON/OFF switch
Switching the appliance off:
♦
Release the ON/OFF switch
Switching to continuous operation:
♦
Press the ON/OFF switch
pressed position with the locking button
Switching off continuous operation:
♦
Press the ON/OFF switch
again.
Adjusting the rotational speed
Press the ON/OFF switch
speed. Increasing the pressure increases the speed.
Changing the direction of rotation
WARNING!
►
The rotation direction switch
be used/adjusted if the appliance is at a
standstill.
♦
Change the direction of rotation by pressing
the rotation direction switch
or right.
PNS 300 A1
you can use the bit
.
as far as the
.
.
.
. Lock it in the
.
and release it
lightly for a low
may only
towards the left
Activate lock
♦
Push the rotation direction switch
middle position. The ON/OFF switch
blocked.
Maintenance and cleaning
WARNING! RISK OF INJURY!
Switch the appliance off and remove
the power plug before starting any
work on the appliance.
The appliance is maintenance-free.
■
The appliance must always be kept clean, dry
and free from oil or grease.
■
Never allow liquids to get into the appliance.
■
Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
WARNING!
►
If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or an authorised representative in order to
avoid safety hazards.
NOTE
►
Spare parts which are not listed (e.g. carbon
brushes, switches) can be ordered using our
service hotline.
►
Have the carbon brushes replaced by the
manufacturer, by Customer Service or a
similarly qualified person.
into the
is
GB │ IE
│
17
■
Publicité
