Publicité
Before use
WARNING!
►
Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Changing tools
Your appliance has a fully automatic spindle lock
.
When the motor is stopped, the power train locks
so that the chuck
can be opened by turning
it
. After you have attached the desired tool
and tightened it by turning the chuck
continue working. The spindle lock is automatically
released when the motor starts (ON/OFF switch
pressed).
Torque preselection/selecting the
operating mode
You can adjust the torque on the torque selection
ring
and select the drill setting .
♦
Select a low level for small screws or soft
materials.
♦
Select a high level for large screws, hard materi-
als or removing screws.
♦
Select the drill setting for drilling work by
adjusting the torque selection ring
position .
│
GB │ IE
■
16
2-speed gearbox
CAUTION!
►
Operate the speed selector switch
when the appliance is at a standstill. Other-
wise, the appliance could be damaged.
In first gear (speed selector switch
tion: 1)
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear (speed selector switch
, you can
position: 2)
you can reach a speed of approx. 1600 rpm for
carrying out drilling work.
Removing the chuck
If you want to use the bit holder
remove the chuck
Removing the chuck:
♦
Hold the chuck
♦
Pull/push the chuck ring
the chuck
The chuck
removed towards the front.
to the
Attaching the quick-release chuck:
♦
To replace the chuck
towards the quick-release chuck and push the
chuck
NOTE
►
If the chuck
into place, turn the chuck ring
, you must
.
firmly from the front.
in the direction of
.
is now unlocked and can be
, pull the chuck ring
fully on.
does not automatically click
PNS 300 A1
only
in posi-
in
.
Publicité
