Publicité
EN
CLEANING AND MAINTENANCE
During cleaning, the machine must be switched off and the plug unplugged. We
strongly recommend that you do not immerse any part of the machine in water or
other liquids. To clean, simply wipe with a clean damp cloth and dry before storing.
Cleaning the filters, filter holder and brew head
The stainless steel filters must be cleaned thoroughly. The filter holder should be
rinsed under running water immediately after use to remove any coffee residue.
Periodically run water through the machine with the filter holder in place, but
without ground coffee, to rinse out any remaining coffee grounds.
Use a damp, clean cloth to clean and wipe well inside the brew head to remove any
coffee residue.
Cleaning the outer housing/cup warming plate
Do not use ordinary or aggressive cleaning agents to clean the outer casing. Use a
soft, damp cloth to clean the outer casing and cup warming plate.
Cleaning the drip tray rack
The small rack must be removed, cleaned and emptied frequently, especially when
the drip tray is full. The rack can be washed and rinsed thoroughly in warm, soapy
water. Use a non-abrasive detergent (do not use abrasive cleaners, pads or cloths
that may scratch the surface).
Cleaning the drip tray
The drip tray must be removed when the stand is removed. Then clean it with a
soft, damp cloth (do not use abrasive cleaners or scouring agents).
Note: Do not clean any parts or accessories in a dishwasher.
Cleaning the steam wand
You will need to clean the steam wand after steaming milk. Use a damp cloth to
wipe the steam wand and then turn the steam wand back into the drip tray, facing
back into the drip tray, you must briefly turn the steam control knob to be on. This
will release any remaining milk from inside the steam wand. Make sure that the
steam knob is in the OFF position. Switch off the machine, unplug the power cord
and allow the machine to cool down. If the steam wand remains blocked, use the
piercing tool to clean the opening.
29
Publicité
