Publicité
4.
Pour in the correct quantity of coffee beans and close the lid of the bean
hopper.
5.
Plug the machine in, press the On/Off button, all indicator lights will flash
three times and the machine will beep once. At the same time, the two-cup
button, one-cup button and steam warm-up button will flash slowly. (Make
sure the steam warm-up button is in the "
position, the four lights will flash at the same time; if the bean hopper is not
properly fitted or the bean hopper knob is not turned to the correct position,
two lights on the right will not work).
6.
If the "One cup" and "Two cups" button indicators are lit continuously, press
the "Two cups" button and let hot water flow out to clean the filter or coffee
cup.
Grinding coffee powder
1.
If you use the machine with one cup filter, please press the button of „filter
size" once while the indicator light will be off, then the machine will make out
one cup powder amount.
2.
If you use the machine with a two-cup filter, please press the button of „Filter
size" to let the indicator light up (default setting is two-cup filter size). Then
the machine will make two cups of powder amount.
3.
Set the „Grinder quantity knob" to the appropriate position.
Note: The type of coffee beans and the thickness of the coffee powder will
affect the amount of powder.
4.
Place the funnel in the funnel holder, push the funnel towards the "Grind
beans switch" and the machine will start to work. During this time, turn the
"Grind adjustment knob" to adjust the desired powder thickness. When
the amount of powder reaches the desired amount, press the "Grind beans
switch" again to stop grinding beans; or press the set amount of powder and
work until the machine automatically stops grinding beans. (Please ensure
that the motor is running when adjusting the powder thickness).
bean box sealing ring
" position. If it is in "
"
EN
25
Publicité
