Publicité
27. Storage of the device
WARNING:
later starting difficult and causes permanent damage
1. Perform all general maintenance recommended in the maintenance section of
your user manual.
2. Clean the exterior of the device, drive axle, protective shield, and nylon cutting head.
3. Drain fuel from the fuel tank.
4. After fuel is drained, start the device.
5. Let the device idle until the device stops by itself. This will clean the carburetor of fuel.
6. Let the device cool down (about 5 minutes).
7. Use a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter rope
slowly several times to coat the internal components. Replace the spark plug.
9. Store the device in a cool, dry place away from any ignition source such as an oil burner, water
heater, etc.
TRANSPORT PROTECTION
Make sure that the device is well-secured during transport to avoid fuel loss, damage, or injury.
Install transport protection for metal sheets during transport and storage
Manual_FX-WP143_FX-WP152_Int24_rev11
Failure to follow these steps may result in carburetor fouling. This makes
42
Publicité
