Publicité
tight.
NOTE
Dry operation of the pump will cause damage to the pump seals. If the pump runs dry, switch off the
motor immediately and let the pump cool down before pre-pumping.
23. Cold start of the Engine
1.
Place the device on a firm and flat surface.
Press the Start/Stop switch.
1
2.
Move the choke lever upwards to "COLD START."
3.
Press the carburetor pump about 8-10 times (until gasoline flows in the line)
4.
Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, especially fast train will provide a vital spark and start the engine
4
Manual_FX-WP143_FX-WP152_Int24_rev11
2
5
38
3
Publicité
