Publicité
5.
Then set the choke lever to the "WARM START" position
6.
Let the engine warm-up for about 10 minutes at idle
If the device does not start after repeated attempts, refer to troubleshooting chapters.
NOTE:
Always pull the starter cord straight out. Pulling the starter at an angle will cause the rope to
NOTE:
rub against the eyelet. Pulling the starter at an angle can cause the starter cord to fray or break.
Always hold the starter handle firmly when the rope pulls back.
Never let the rope be thrown back from the pulled-out position.
This could damage the starter device.
Adjusting the pump capacity
After the engine has been started, the pumping capacity can be
adjusted via the throttle lever. Move the throttle lever towards the
device to increase the flow rate, move it forward towards the pipe to
decrease it (only for model FX-WP152)
24. Warm start of the engine
1.
Place the device on a firm and flat surface.
2.
Move the engine stop switch down
3.
Slide the choke to the "WARM START" position
4.
Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, especially fast train will provide a vital spark and start the engine
If the device does not start, please proceed again according to "Cold start of the device
25. Stopping the device
Slide the throttle stick to the LOW position. Let the device return to idle. Push the engine stop
switch to the OFF position upwards until the device stops. If it does not control, pull out the spark
plug connector in an emergency. Never leave the device unattended while it is running.
Manual_FX-WP143_FX-WP152_Int24_rev11
39
LOW
HIGH
Publicité
