About This Documentation - Aventics 8940400122 Mode D'emploi

AVENTICS | 8940400122, R412010842 | R412022205–BAL–001–AB | Deutsch/English
Pneumatik
zulässiges Medium
Druckluftqualität nach
ISO 8573-1:2010
Einstellbereich
Toleranz
Überdrucksicherheit
Normen und Richtlinien
EN 61326-1: Elektrische Mess-, Steuer-, Regel- und La-
borgeräte - EMV-Anforderungen - Teil 1: Allgemeine
Anforderungen
EN 61000-6-2: Elektromagnetische Verträglichkeit
(EMV) - Teil 6-2: Fachgrundnormen - Störfestigkeit für
Industriebereiche
10 Zubehör
Bauteil
Schutzkappen
Druckluft
max. Partikelgröße: ≤ 40 μm
3
Ölgehalt: 0–40 mg/m
Der Drucktaupunkt muss
mindestens 15 °C unter der
Umgebungs- und Mediums-
temperatur liegen und darf
max. 3 °C betragen.
8940400122: 1–10 bar
R412010842: 0,1–1 bar
± 0,2 bar bei Raumtempera-
tur
bis 20 bar (Ü) statisch, dyna-
mischer Wert 30–50% weni-
ger
Materialnummer
8941600114
1

About This Documentation

Documentation validity
This documentation applies to diaphragm pressure
switches with the material numbers 8940400122 and
R412010842.
This documentation is intended for installers, operators,
and service technicians.
Required and supplementary
documentation
O Only commission the product once you have obtained
the system documentation and understood and
complied with its contents.
Presentation of information
Safety notices
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injuries.
Indicates that damage may be inflicted on the product
or the environment.
Symbols
Operation may be impaired if this information is
disregarded.
2 Notes on Safety
About this chapter
The product has been manufactured according to the
accepted rules of current technology. Even so, there is risk
of injury and damage to equipment if the following chapter
and safety instructions of this documentation are not
followed.
O Read these instructions completely before working
with the product.
O Keep this documentation in a location where it is
accessible to all users at all times.
O Always include the documentation when you pass the
product on to third parties.
CAUTION
NOTICE
4