Publicité
Deje que el motor se caliente durante un minuto
antes de empezar a trabajar con la máquina.
6.4.3. HOT ENGINE START
1. Press the oil ejector (1) at least 10 times, turn the
choke handle (2) to the half-open position
2. Pull the starter (3) until the machine starts and then
turn the choke handle to the open position
6.4.4. ENGINE STOPPING
1. Release the throttle trigger (4) and let the engine
idle for a few seconds.
2. Stop the engine by moving the switch to the "O"
(stop) position.
6.4.5. POINTS TO BE VERIFIED AFTER MACHINE
STARTS
It is neccesary to pay attention to posible loosening
or overheating of parts of the machine. If you detect
any anomalies stop inmediatly the machine and check
it carefully. In case of failure take the machine to
the repair service. In any case you should continue
working if you feel that the performance is not correct.
Do not use the machine if it is damaged or
incorrectly regulated.
7. MACHINE USAGE
Only use this machine for those jobs for which it
has been designed. The use of this machine for other
uses is dangerous and could cause damages to the
user and/or the machine.
Do not start the machine in a closed area. The exhaust
fumes, the vapours of the petrol and oil, all contain
carbon monoxide and other dangerous chemical
substances. In case of gas concentration due to
insufficient ventilation, eliminate from the work area
everything that impedes the correct flow of air and do
not work in this area again until it is well ventilated
and the gas concentration does not happen again.
.
Mow only at daylight or in good artificial light. Do not
use this machine at night, with fog and with reduced
.
visibility. Always make sure that you can clearly see all
the working area.
Avoid operating the equipment in wet grass, where
feasible. Take special care when using this machine
in the rain or after rain because the ground is slippery
and you can slip.
If you slip or fall stop accelerating and move the
switch to "O" (Off).
Do not rely solely on the warning signs on the
machine. Be always alert.
It is neccesary to pay attention to posible loosening or
overheating of parts of the machine. If you detect any
anomalies stop inmediatly the machine and check it
carefully. In case of failure take the machine to
the repair service. In any case you should continue
35/128
English
Publicité
