Publicité
English
WARNINGS:
- Always switch off the engine before refueling.
-
Do not start the machine in a closed area.
The exhaust fumesand the vapours of the
petrol all contain carbon monoxide and
other dangerous chemical substances. In case of
gas concentration due to insufficient ventilation,
eliminate from the work area everything that
impedes the correct flow of air and do not work in
this area again until it is well ventilated and the gas
concentration does not happen again.
- Do not refill fuel in areas where flames, sparks or
hot sources are. Refill only in ventilated areas with
engine off. Do not overfill the fuel to try to overfill
the fuel tank. In case of fuel leakage, eliminate
these before starting the machine, do not attempt
to start the engine but move the machine away
from the area of spillage and avoid creating any
source of ignition until petrol vapours have
dissipated.
- Stay away at least 3 meters from the zone where
you have refueled before started the machine.
- Refill fuel before to start the machine. Do not
unscrew the combustible tank cap while the
engine is running or engine is hot.
- Do not use fuel with ethanol or methanol because
will damage the engine.
6.4. START UP
6.4.1. CHECK POINTS BEFORE STARTING
Do not use this machine if it becomes damaged or
wrongly regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user to the machine and for people, animals and
things you may have around.
Verify that:
- The machine completely and look for loose parts
(screws, nuts, etc.) and damages.
- There are not fuel leaks.
- Verify that the disk or head is not damaged.
- Check the air filter is clean. Clean the filter if
necessary.
Press, repair or replace everything you need before
using the machine.
Do not use attachments on this machine out of our
recommendations because their use may cause
serious injury to the user, the machine and the people,
animals and things close to the machine.
Before starting the machine make sure that all moving
parts of the machine are not in contact with any
object.
Place the machine on a flat, stable surface to
start it.
• Put the harness on
• Hook the harness to the olive shaker ring.
• Move the acelerator to the desired work position.
6.4.2. ARRANQUE DEL MOTOR EN FRÍO
6.4.2. COLD ENGINE START
1. Press the fuel choke (1) at least 10 times, move the
air handle (2) to the closed position
2. At the same time, press the throttle trigger (4),
safety handle (6) and lock switch (5).
3. Pull the starter (3) until an engine explosion is
heard.
4. Turn the air handle (2) to the half-open position
and continue pulling the starter (3) until it starts.
5. Wait 10 seconds after starting, and turn the choke
handle (2) to the open position
Let the engine warm up for one minute before starting
to operate the machine.
34/128
.
.
Publicité
