Scheppach HSC130 Traduction Des Instructions D'origine page 17

Turning the upper and lower knives
• When changing the blades, loosen the screws (Fig.
4, Pos. 1) on the upper or lower blade (Fig. 4, Pos. 2)
as required using a Phillips screwdriver.
• Remove the upper or lower blade as required (Fig.
4, Pos. 2).
• Turn the removed knife and replace it in the stone
cutter so that an unworn blade edge forms the new
cutting edge.
• Tighten all screws (Fig. 4, Pos. 1) again.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Blade
* may not be included in the scope of supply!
14. Troubleshooting
Fault
Stone doesn't break
Material doesn't lie flat
Cutting lever won't
move
Possible cause
Blade worn
Stone chips on the
support
Stone chips in moving parts
www.scheppach.com
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
13. Disposal and recycling
Notes for packaging
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
Remedy
Change knife
Clean the support
Clean the stone cutter
GB | 17