Setting Up The Light; Replacing The Rechargeable Battery - MELINERA HG00777A Instructions D'utilisation Et Consignes De Sécurité

2. Move the ON / OFF switch
switch the light on.
3. Insert the solar cell housing
tighten by turning it clockwise.
4. Place the light on to the pole
5. Take out the ground stake
it into the pole
Fig. C).
6. Your solar lamp is ready for use (see Fig. D).

Setting up the light

Insert the assembled solar light far enough into the
ground (lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance at all
times. Do not use any force when assembling or setting-up
the product, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set the solar
garden lamp up in a place where the solar cell will get
direct sunlight for as long as possible.
Make sure that the solar cell is not influenced by any
other source of light such as yard or street lighting as
otherwise the light will not come on in twilight.
The light automatically switches on in twilight conditions and
off again when normal outdoor lighting conditions return.

Replacing the rechargeable battery

The battery should be replaced every 12 months to ensure
optimum performance.
1. Separate the solar cell housing
by moving it anti-clockwise (see Fig. A). Switch off the
2
lamp with the ON- / OFF-switch
2. Loosen the fastening screws
head screwdriver and then lever out the battery compart-
ment lid
7
slot screwdriver (see Fig. B).
3. Take care not to damage the cables and cable connec-
tions (see Fig. B).
4. Exchange the old rechargeable battery
Take care to the correct polarity, when inserting the new
rechargeable battery. The polarity is indicated in the bat-
tery compartment. The new rechargeable battery has to
have the same technical data like the old one.
5. Now again fasten the battery compartment lid
the fastening screws
driver. Slide the On / Off switch
with the tip facing downwards (see
3
of the solar cell housing
by using a small cross head screw-
6
into the ON position to
5
into the lamp shade
1
.
3
from the pole
4
from the lamp shade
1
.
5
by using a small cross
6
with the help of a
1
8
to the position ON.
5
and
2
and insert
3
to a new one.
, fasten
7
GB/IE 9