Publicité
12 Operating the Lawn Mower
► Press the locking button and release it again.
► Pull the control bar fully in the direction of the
handlebar and release it again.
► If the locking button or the control bar is stiff or
does not spring back into the initial position:
do not use the lawn mower and consult a
STIHL specialist dealer.
The locking button or the control bar is defec‐
tive.
Activate the blade
► Fit the battery.
► Press the locking button with the right hand
and hold.
► Pull the control bar with the left hand fully in
the direction of the handlebar and hold so the
thumb encloses the handlebar.
The blade rotates.
► Release the locking button and control bar.
The blade stops turning after a short time.
► If the blade continues to turn: remove the bat‐
tery and consult a STIHL specialist dealer.
The lawn mower is defective.
11.2
Checking the Blade
► Switch the lawn mower off and remove the
battery.
► Upend the lawn mower,
► Measure the following:
– Thickness a
– Width b
– Sharpening angle c
► If the minimum thickness or minimum width is
fallen below: replace the blade,
► If the sharpening angle is not correct: sharpen
the blade,
20.2.
► If anything is unclear: consult a STIHL special‐
ist dealer.
11.3
Testing the Battery
► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
0478-131-9600-B
16.1.
20.2.
12 Operating the Lawn Mower
12.1
Holding and Guiding the Lawn
Mower
► Hold the handlebar with both hands so the
thumbs enclose the handlebar.
12.2
Setting the cutting height
Seven cutting heights can be set:
– 20 mm = position 1
– 30 mm = position 2
– 40 mm = position 3
– 55 mm = position 4
– 70 mm = position 5
– 85 mm = position 6
– 100 mm = position 7
The positions are indicated on the lawn mower.
Setting the cutting height
► Switch the lawn mower off.
The blade must not be turning.
► Place the lawn mower on a level surface.
► Hold the lawn mower at handle (1).
► Press and hold lever (2).
► Move the lawn mower to the desired position
by raising and lowering the lever.
The current cutting height can be read off at
cutting height indicator (3) by means of mark‐
ing (4).
► Release lever (2).
The lawn mower engages.
12.3
Mowing and Mulching
The lawn mower is equipped with a multi-blade
and can be used for mowing or mulching.
English
45
Publicité
