Publicité
GB
Caution during operation:
If the throttle lever is opened fully in a no-load operation, the engine
rotation is increased to 10,000 rpm or more. Never operate the engine
at a higher speed than required and at an approximate speed of
6,000 - 8,000 rpm.
•First place the machine on the ground.
• Give a gentle push on the primer pump (12) repeatedly (7 -10 times)
until fuel comes into the primer pump.
• Move the choke lever (11) to the top position ( |XJ )•
• Firmly hold the holder case by your left hand as illustrated.
• Slowly withdraw the starter grip until resistance is felt and continue
with a smart pull.
• Do not pull out the starter rope to its full extent
do not allow
the starter handle to be retracted without control,ensure that
it is retracted slowly.
• Repeat the starting operation until initial ignitions are heard.
• Depress the choke lever ( | + | ) and pull the starter rope again
until the engine starts.
• As soon as the engine starts, immediately tap and release the
throttle, thus releasing the half-throttle lock so that the engine can
run in idle.
• Run the engine for approximately one minute at a moderate speed
before applying full throttle.
Starting the warm engine
•As described above except without moving the choke lever (choke
lever remains in the down position ( |^| ).
Stopping
• Release the throttle lever (6), (7) fully, and when the engine rpm
has lowered, push the stop switch (1), (9) to ''STOP" position.
Engine will stop.
18
Publicité
