Publicité
GB
Mounting of protector
To meet the applicable safety provisions, only the tool/protector combination as indicated in the table must be used.
RBC220, RBC250
Star brade
Protector for metal cutter blade
Be sure to use genuine MAKITA cutter blade or nylon cutting head.
• The cutter blade must be well polished, tree of cracks or
breakage.
I! the cutter blade hits against a stone during operation, stop the
engine and check the blade immediately.
• Polish or replace the cutter blade every three hours of operation.
For RBC220, RBC250
• The outside diameter of the cutter blade must be 230 mm (9-1/16").
Never use any blades surpassing 230 mm (9-1/16") in outside
diameter.
Grass-pasture
Part No. 6208501400
Part No. 6258028001
RBC221, RBC251
Nylon cutting head
Protector for nylon cutting head
43
434
Part No. 6218014001
Part No. 6218008002
A
CAUTION:
The appropriate protector must always be installed, for your own safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being in place in not permitted.
For RBC220, RBC250, RBC221, RBC251
• Install the clamp (3) on the drive shaft so that the projection of
the clamp (3) is inserted into the opening between the gear case
(1) and the shaft.
Secure the protector (4) with the installation bolts M6 x 30 (2).
For RST250
•Attach the protector (7) to the shaft.
• Insert the nut M6 (6) into the hex hole in the protector (7).
•Secure the protector with the installation bolt M6 x 45 (5).
NOTE:
Do not tighten the installation bolt M6 x 45 (5) excessivley.
14
Publicité
