Publicité
ForTRBC220, RBC221, RBC250 and RBC251, the engine and drive shaft are installed on the machine at factory. Install the throttle
wire and ignition wire only.
For machines with U handle
• Connect the throttle wire and firmly close the cable joint.
• Squeeze the throttle lever to make sure that the throttle wire moves
smoothly.
• Connect the switch cords to the two cords from the engine by
inserting one into the other.
• Wrap the waist pad around the drive shaft so that the hanger (7)
will protrude through the slit in the waist pad and the throttle wire
and the cords (9) will also be wrapped under the waist pad (8).
• Insert the bullet connectors (10) through the holes in the cover (IT
For machine with J handle
• Always pass the throttle wire through the hole in the undersic
of the rear grip (12).
NOTE:
Loose throttle wire will disturb you in operation. If it is caught ar
pulled by something, engine rpm will increase unexpectedly.
Publicité
