Publicité
For machine with J handle
• Match the protrusions on the handle joint (17) to the holes in the
underside of the handle (16). Tighten the four socket head bolts
M5 (15) evenly to secure the handle.
• Secure the throttle wire with the clip wire (20) as shown in the figure
for easy operation.
For machine with Loop handle
• Attach the handle to the shaft.
•Install the handle joint (22) on the handle. Insert the installatior
bolt M6 x 45 (23) through the hole in the handle. Semitighten the
installation bolt M6 x 45 (23).
• Adjust the handle to the desired position over 200 mm away frorr
the rear grip (24) and tighten the installation bolt M6 x 45 (23)
Publicité
