Publicité
GB
12
•Connect the throttle wire and firmly close the cable joint.
• Squeeze the throttle lever to make sure that the throttle wire n
smoothly.
• Connect the switch cords to the two cords from the engir
inserting one into the other.
• Insert the bullet connectors (10) through the holes in the cove
For machines with U handle
• Loosen the handle installation bolts (12).
• insert the handle into the handle joint (13) fully.
• After making sure that the handle is installed properly, tighte
installation bolts (12) to secure the handle.
• Secure the throttle wire with the clip wire (14) as shown in the
for easy operation.
Publicité
