Settings - Trilux 3331 G2 +HFS Série Mode D'emploi Et Instructions D'installation

Settings

All settings are carried out to the corresponding TRILUX luminaire using the
LMS HFSB/X RMC remote control (TOC 64 878 00).
Each valid button-press is confirmed by the red LED on the sensor flashing; the
luminaire dims into installation mode to avoid glare.
min 1 / 3 2 / 3
5 15 30
min min min
1 2
install
set %
10
level
min
0 % 10 % 20 %
50 % 60 % 70 %
LOW/HIGH
LEVEL
swarm/
40 % 50 %
all
90 % 100 %
S
_
E
N
reset
N
S
max
x
min
3
4 h
on/off
30 %
80 %
send
x
last
min
send
all
Range setting (factory setting max.)
Pressing the button sets the range from
a min. of 1 m, 1 / 3, 2 / 3 to a max. of 8 m
diameter.
Time setting / delay time
(factory setting: 5 minutes)
The required illumination duration
following the last movement detection
can be set to 5 minutes, 15 minutes to
30 minutes by pressing the buttons.
Individual illumination duration
Illumination duration is set to an individu-
ally desired time.
Each button-press increases the desired
time setting by 1 minute.
Twilight setting
(factory setting = daylight mode)
The desired response threshold can
be set from 1 = approx. 10, 2 = approx.
30-50, 3 = 300 lux.
Night mode
Switch-on only with low ambient
brightness (< 2 lux).
Daylight mode
Switch-on with all movements, indepen-
dent of ambient brightness.
25
E