Abicor Binzel ABIPLAS CUT Mode D'emploi page 35

®
ABIPLAS CUT
Spacer
• Distance spring
• Bevel nozzle
• Hole piercing cap
Mount for the machine cutting torch
• The ABIPLAS
machine by a mount.
• The machine cutting torch is clamped to the clamping area marked as SB1 using a
clamping sleeve. In the absence of a clamping sleeve, it can be clamped to SB2.
 Fig. 7 on page EN-17
Fig. 3
7 Operation
7.1 Setting up the torch body
WARNING
Risk of injury and device damage as a result of improper operation
Non-observance can result in injuries and device damage.
• In the case of a split protective cap, the cap body and spatter protector make up one
functional unit. For safety reasons, the plasma cutting torch equipped with the cap body
must not be used without a spatter protector.
CAUTION
Risk of injury and device damage as a result of improper operation
Non-observance can result in injuries and device damage.
• A loose protective cap presents a hazard and can lead to increased insulator, electrode
and swirl ring wear or even to destruction of the torch body.
• A dirty protective cap in the area of the interior air guide and soiled swirl ring holes
reduce the air throughput and the cooling. This increases the wear to the insulator,
electrode, and swirl ring and can destroy the torch body.
• A worn-out spatter protector must be replaced if required.
BAL.0099 • 2021-08-20
®
CUT MT 70/110/150 machine cutting torches are attached to the
Mount for the machine cutting torch
7 Operation
EN - 11