Abicor Binzel ABIPLAS CUT Mode D'emploi page 26

EN Translation of the original operating instructions
© The manufacturer reserves the right, at any time and without prior notice, to make such changes
and amendments to these operating instructions as become necessary due to misprints, inaccuracies
or product enhancements. Such changes will, however, be incorporated into subsequent editions of
the operating instructions.
All brand names and trademarks that appear in these operating instructions are the property of their
respective owners/manufacturers.
Our latest product documents as well as all contact details for the ABICOR BINZEL national
subsidiaries and partners worldwide can be found on our website at www.binzel-abicor.com.
1 Identification
1.1 Marking
2 Safety
2.1 Designated use
2.2 Classification of the warnings
2.3 Special warnings for operation
2.4 Emergency information
3 Product description
3.1 Technical data
3.2 Signs and symbols used
3.3 Nameplate
4 Scope of delivery
5 Function
6 Putting into operation
Setting up the ABIPLAS
6.1
manual cutting torch
6.1.1 Cutting torch body
6.1.2 Handle
6.2 Setting up the ABIPLAS
machine cutting torch
6.2.1 Machine torch body
6.2.2 Cable assembly
6.2.3 Accessories
EN - 2
EN-3
EN-3
EN-3
EN-3
EN-3
EN-4
EN-4
EN-4
EN-5
EN-7
EN-7
EN-8
EN-8
EN-9
®
CUT
EN-9
EN-9
EN-9
®
CUT MT
EN-10
EN-10
EN-10
EN-10
7 Operation
7.1 Setting up the torch body
7.2 Connecting the plasma
cutting torch
7.2.1 Compressed air as plasma
and cooling gas
7.2.2 Filtered compressed air free
from oil and water
7.3 Connecting the machine torch
7.4 Plasma cutting torch with central
connector
7.5 Before switching on
7.6 Igniting the torch
7.7 Cutting process
8 Putting out of operation
9 Maintenance and cleaning EN-21
9.1 Cable assembly
9.2 Cutting torch
10 Troubleshooting
11 Disposal
®
ABIPLAS CUT
EN-11
EN-11
EN-17
EN-18
EN-18
EN-19
EN-19
EN-19
EN-20
EN-20
EN-21
EN-22
EN-22
EN-22
EN-24
BAL.0099 • 2021-08-20