Abicor Binzel ABIPLAS CUT Mode D'emploi page 33

®
ABIPLAS CUT
6 Putting into operation
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing,
assembly, disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Close the compressed air supply.
• Switch off the entire welding system.
DANGER
Risk of injury and device damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorised persons.
• Operating, maintenance, cleaning and repair work must only be carried out by qualified
personnel (in Germany, see TRBS 1203).
NOTICE
• Please take note of the following instructions:
 3 Product description on page EN-4
6.1 Setting up the
6.1.1 Cutting torch body
The ABIPLAS
A and 150 A, each based on a duty cycle of 60%. The cutting torch head is positioned at an
angle of 110° to the handle axis. The plasma nozzle, protective cap, swirl ring, electrode and
insulator are all wear parts that can be easily replaced by inserting or screwing on spare parts.
To protect the operator, the screw-on protective cap is equipped with a safety cut-out
mechanism, which will automatically interrupt the inrush current circuit if the protective cap is
removed. Accessories such as torch carriage, circular torch guide, template cutting guide and
spacer can be attached and locked onto the outer contour of the protective caps.
6.1.2 Handle
The ergonomically shaped handle is equipped with a trigger. A trigger guard prevents the
cutting torch being accidentally switched on when laid down.
BAL.0099 • 2021-08-20
®
CUT manual cutting torch
ABIPLAS
®
CUT cutting torch bodies are available in the three output currents 70 A, 110
6 Putting into operation
EN - 9