eluxe ELPC020SET2 Manuel De L'utilisateur Et D'installation page 51

5. Heating operation (this function is not available for a cold-single unit)
- Press the "Mode" button till the "Heat" icon appears.
- Press the " " or " " button to select desired room temperature. (16ºC-31ºC)
- Press the "Fan Speed"button to select wind speed.
6. Timer operation
Timer ON setting:
- When the air-conditioner is OFF, press the "Timer " button and select desired ON
time through the temperature and time setting buttons.
- "Preset ON Time"is displayed on the operation panel.
- ON time can be regulated at any time in 0-24hours.
- Press the"Timer"button again to confirm, Timer indicator turns on.
- To deactivate the timer function, press "Timer" button until timer indicator turns off.
Timer OFF setting
- When the air-conditioner ON, press "Timer " button and select a desired OFF time
through the temperature and time setting buttons.
- "Preset OFF Time"is displayed on the operation panel. OFF time can be regulated at
any time in 0-24hours.
- Press the "Timer" button again to confirm, Timer indicator turns on.
- To deactivate the timer function, press "Timer "button until timer indicator turns off.
7. SLEEP mode
-While in cooling mode, press the SLEEP key to set the temperature. It increases 1ºC
after an hour and at most increases 2ºC after 2 hours.
-While in heating mode, press the SLEEP key to set the temperature. lt decreases 1ºC
after an hour and at most decreases 2ºC after 2 hours.
-Press the SLEEP key again can cancel the setting.
8. Water Drainage
Water Full Alarm Function
The inner water tray in the air-conditioner has one water level safety switches, it
controls the water level. When water level reaches an anticipated height, the water full
indicator lights up. When the water is full, please remove the rubber blockage from
the drainage hole at the bottom of unit, and drain all water outside.
51