Cleaning And Care; Maintenance And Repair - ALFRA ROTABEST 80SP Mode D'emploi

cLEAning And cARE

Pull plug prior to cleaning to avoid injuries by unintentionally switching motor on.
!
• Clean the outside of the motor with dry compressed air. Check connecting power cords for damages.
• Clean and grease sliding surfaces regularly. Should lateral play arise by wear of the linear guide,
this can be corrected by adjusting the laterally positioned set screws (F).
• Carbon brushes should be replaced after appox. 250 hours running time.
• After finishing work, we recommend storing the metal core drilling machine in the transport
case in a lying position.
• Check the underside of the magnet for scratches, pressure points or cracks. Have the magnet repaired by
the manufacturer if necessary
• Check the blocking function of the safety tab on the lever

mAinTEnAncE And REPAiR

Maintenance, check-ups and repairs are only to be made by electronics specialists, according to the valid
regulations of the respective country.
!
Only use original ALFRA spare parts.
A spare-part list is at the end of this operation manual.
The metal core drilling machine ALFRA ROTABEST should be serviced after appox. 250 hours running time
by our ALFRA workshop or appointed dealers. The gear oil (Lubcon, Turmogearoil PE 150 300ml) should be
exchanged as well as the carbon brushes.
17