Start-Up - ALFRA ROTABEST 80SP Mode D'emploi

START-uP

You have received a completely assembled magnetic core drilling machine and detailed operation
manual. Please check the condition of the goods on receipt for any transport damage and make sure the
delivery is complete. Otherwise contact the manufacturer immediately.
!
Read the operation manual before using the device for the first time!
1. First, check the cable and plug for damage and insert the plug in the mains socket.
2. Insert the core drill in the tool holder on the spindle of the motor and check the stability and exact
position of the tool.
3. The lever is pointing upwards meaning the switchable permanent magnet is deactivated so that you
can position the machine. A slight magnetic pre-tension helps with aligning the machine on walls or
ceilings.
4. Secure the drilling unit using the safety belt when working on walls and ceilings.
5. Press the lever down as far as it will go and make sure that the safety tab audibly latches into place.
6. After lowering the lever you can activate the driving motor via the side motor switch by pressing
the green ON switch.
7. By turning the rotary handle, lower the motor and the rotating drill slowly to the work piece. Ensure
sufficient cooling during the drilling process.
8. When you have finished drilling, move the motor upwards and deactivate it with the red OFF switch
on the motor.
9. Once the motor has come to a complete standstill, remove the swarf, metal shavings and other drilling
waste using a swarf hook.
10. To deactivate the permanent magnet, press the black safety tab inwards using the ball of your hand
and lift the lever up.
11. Only then clean the underside of the magnet of swarf, matal shavings and any other residue
using leather work gloves.
14