Publicité
you will avoid the danger of burns. Bulbs give
off a lot of heat around the top of the lamp.
Do not cover the light or the mains plug with
objects. Excessive heat can result in a fire.
Parts of the lamp can reach temperatures over
60 °C during use. Do not touch or adjust the
lamp whilst on. Allow the lamp to first cool
down completely.
Never leave the lamp operating unattended.
ATTENTION!
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instrument
(e.g. magnifier).
The illuminant in this light must be replaced by
the manufacturer or an authorised technician
or a similarly qualified person.
Working safely
Install the light so that it is protected from
moisture and dirt.
Prepare carefully before assembly and allow
yourself enough time. Lay out all the individual
components and additional tools or materials
required so that you can see and reach them.
Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
To disconnect the lamp completely from the
power supply, the mains plug must be discon-
nected from the mains socket.
Preparing the product for use
Assembling the lamp
Note: You will require a second person to help
with the assembly of the product.
Note: Please ensure that you pull the cable during
fitting slowly through the base
Remove the transport locks
Connect the sections of tube
place.
.
4
from the tube
.
7
1
and screw in
1
Safety/Preparing the product for use
Note: Be sure to screw in the section of tube
as far in as possible to ensure the light is stable.
Be sure not to pinch the mains lead running
through the tube
1
Screw the tube
1
Ensure that they are securely tightened.
Tighten the nut
at the underside of the base
5
if it has become loose.
Note: Be sure to hold the tube
tightening the nut
5
Note: Ensure the cable is inside the designated
opening in the base
Position the uplight upright.
Remove the screws with the pre-installed wash-
ers
+
(rubber and plastic) from the spot-
14
15
light head.
Important: Remove the clear transport lock
(plastic)
from the lamp head.
12
Ensure that one washer (plastic)
(rubber)
is placed on each of the screws
14
When screwing the glass bowl
sure that the washer (rubber)
glass bowl
. The washer (plastic)
13
at the edge of the glass bowl
Carefully tighten the screws
Loosen the box nuts
Screw the spacer
10
middle of the lamp head.
Place the cover
18
Screw the box nuts
Plug the mains plug
been professionally installed.
Your light is now ready for operation.
Switching the lamp on/off
Use the touch switch
on or off.
Use the touch switch
lamp on and off.
.
onto the base
.
4
tight when
1
.
so it cannot be pinched.
4
and one washer
15
in tight, en-
13
is under the
14
must be
15
.
13
.
16
from the spacers
17
10
onto the screws
at the
16
over the spacer
.
10
onto the spacers
17
10
into a socket that has
6
to switch the uplight
8
to switch the reading
9
GB/IE
1
4
.
16
.
.
17
Publicité
