Table Des Matières; Specifications; General Information - Hach Micro Dist Manuel D'utilisation

Table of Contents
Specifications on page 3
General information on page 3
Installation on page 7
User interface and navigation
Operation on page 9

Specifications

Specifications are subject to change without notice.
Specification
Dimensions (W x D x H)
Enclosure
Weight
Safety
Pollution degree/installation category
Protection class
Power requirements
Fuse
Operating environment
Sample size
Sample capacity
Tube material
Temperature range
Temperature accuracy
Temperature variation (hole-to-hole)
Controller set point error
Certifications

General information

In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
on page 8
Details
72 x 17 x 15 cm (28.3 x 6.7 x 5.9 in.)
Aluminum
20 kg (45 lb)
Laboratory 61010-1, 61010-2-010 (UL, CSA, EN safety standards)
2; II
I
100-115 VAC, 50/60 Hz, 9-11 A
230 VAC, 50/60 Hz, 5 A
100-115 VAC: 15 A, 250 VAC, slow-blow
230 VAC: 6.3 A, 250 VAC, slow-blow
Temperature: 5 to 40 °C (41 to 104 °F)
Humidity: 92.5%, non-condensing maximum
6.0 mL capacity per Micro Dist tube
21 Micro Dist tubes
Analytical-grade pure polypropylene
30 to 135 °C (86 to 275 °F)
±0.5 °C (0.9 °F)
Less than ±0.5 °C (0.9 °F)
Less than 1% of the temperature set point
100-115 VAC model: UL and CSA safety standards (cETLus mark)
230 VAC model: CE
Maintenance on page 20
Troubleshooting on page 22
Replacement parts and accessories
Appendix on page 24
on page 23
English 3