EUROM Wall Designheat 2000 Wi-Fi Manuel D'utilisation page 25

Device control
1. Press the MODE button once or several times to toggle through the loop of choices:
•
standby mode;
•
fan mode: fan indicator light up;
•
low heat mode: low heat indicator light up;
•
high heat mode: high heat indicator light up;
•
high heat and swing mode: high heat indicator and swing indicator light up.
Temperature mode
1. Press the Temperature and Wi-Fi button to set the desired temperature.
2. The device automatically adjusts the settings to reach the given temperature.
3. The display shows the current temperature.
Remote control
1. Press the MODE button once or several times to switch between:
•
fan mode: fan indicator light up;
•
low heat mode: low heat indicator light up;
•
high heat mode: high heat indicator light up.
Temperature mode
1. Use the Plus or Minus button to set the desired temperature (from 10°C to 35°C).
2. The device automatically adjusts the settings to reach the given temperature.
3. The display shows the current temperature.
Swing mode
1. Press the SWING button (Figure 14, pos. 2).
2. The swing flap (Figure 14, pos. 1) will start to
move.
3. The swing indication will light up.
4. Press the SWING button to turn of the swing
mode.
Swing mode works while in fan mode or in heating
mode.
Standby mode
1. Press the MODE button on the device (Figure 13, pos. 2) or the ON/OFF button on the
remote control (Figure 13, pos. 3).
2. The fan indicator starts flashing and the device will start cooling down within 30 minutes
during normal use and within 5 minutes when using the optional temperature sensor.
3. Never stop the device during the cool down.
4. When the fan indicator turns off, the device is in standby mode.
Figure 14
25