EUROM Wall Designheat 2000 Wi-Fi Manuel D'utilisation page 22

Figure 8
10. Place the supplied bracket on top of the
heater (Figure 9, pos.2 ) with the short side
against the wall.
11. Mark the location of the hole on the wall with
a pencil.
12. Remove the device.
13. Drill a hole at the marked spot and insert a
plug (Figure 9, pos. 3).
14. Replace the device and screw the bracket to
the wall.
Installation
WARNING
Do not use an extension cable, this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 2000 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
22
Figure 9