EUROM Wall Designheat 2000 Wi-Fi Manuel D'utilisation page 24

1. Make sure the ON/OFF switch is in the OFF
position (Figure 12, pos. 3).
2. Connect the temperature sensor connector
(Figure 12, pos. 1) to the sensor plug (Figure
12, pos. 1).
3. Place the temperature sensor approximately
2 meters away from the device.
Operation
WARNING
Before every use, make sure that:
•
•
•
•
•
CAUTION
When the device is turned on it can give off smoke and an odor. This is normal
and will disappear after a few minutes.
1. Set the ON/OFF switch to the ON position
(Figure 13, pos. 1).
2. The display will show the current
temperature.
3. Press the MODE button on the device (Figure
13, pos. 2) or the ON/OFF button on the
remote control (Figure 13, pos. 3).
4. The device will start in fan mode and the fan
indication light will turn on.
24
you operate the device with dry hands;
the device is clean and dry;
the device is not damaged;
the device is not covered or blocked;
the device is securely mounted to the wall.
Figure 12
Figure 13