EUROM Wall Designheat 2000 Wi-Fi Manuel D'utilisation page 21

1. Place the device on a vertical and solid
surface.
2. Place the device with a minimum distance
(Figure 6) of:
•
20 cm to a ceiling or roof;
•
50 cm to the side walls;
•
180 cm from the floor;
•
100 cm clearance on the front side.
3. Do not mount the device:
•
immediately below a socket outlet;
•
on a ceiling or roof.
4. Drill two holes 57.5 cm apart, make sure it is
spirit level.
5. Place the plugs (Figure 7, pos. 2) and the
screws (Figure 7, pos. 3).
6. Screw them until 10 mm from the wall with a
Phillips screwdriver (Figure 7, pos. 1).
7. Place the device with the mounting holes (Figure 8, pos. 3) over the screws (Figure 8,
pos. 1).
8. Slide the device (Figure 8, pos. 2) down and to the right.
9. Check whether the heater is secured tightly. If necessary, tighten the screws (Figure 7,
pos. 2) further into the wall.
Figure 6
Figure 7
21